RE400 manual changes

Key:
4 new document
3 new information
2 error removed
1 little errors
080326 year, month, day,
Chapter,
new text follows

______________
4 080326 

First edition for www pages, for fw 2.0.49.0

______________
3 080418 

2.2. First start of radio modem
Do not switch on more than one radio with default settings at any one time ! Only switch on the next
one after setting and storing IP parameters in the first one.
In default mode radio modems use the same address 192.168.1.2 and communication amongst
themselves thus disturbs IP communication between the PC and configured radio modem.

Tab. 4.1: Technical parameters
Output power software Low 0.3 W
adjustable 
Low 0.3 W
High 2 W

Data rate in RF channel 
2.6 kbps in the 6.25 kHz channel
5.2 kbps in the 12.5 kHz channel
10.4 kbps in the 25 kHz channel

Power consumption 
Idle state (Rx) 6.0W e.g. 430mA/13.8V or 125mA/48V
Low power Tx 9.3W e.g. 670mA/13.8V or 200mA/48V
High power Tx 13.2W e.g. 950mA/13.8V or 280mA/48V

______________
3 080422 

RE160 version removed

5.2. Labelling of Radio Modems
RE390     373,250 - 402,000 MHz
RE410     400,000 – 420,000 MHz (398,750 – 421,500 MHz)
RE430     417,500 – 447,500 MHz
RE450     435,000 466,500 – MHz

______________
1 080423 

2.3. Radio modem configuration
Radio
Repeated packets — when the radio modem receives 2 equal packets one after the
other it is possible to adjust the settings so that the second one will be discarded or
transmitted to a serial or Ethernet port. See Section 2.1.1, “Main mode”

RS232
MTU — the incoming packet is closed at this size. A shorter packet is closed at Idle.
Longer packet is sent to RFC in the length MTU, the remaining part is saved in the input
buffer and is sent to RFC subsequently. See Section 2.1.1, “Main mode”

______________
1 080724 

3.3. Ethernet interface
Fig. 3.3: RJ-45F   - exchanged



______________
080805
this changelog closed