Help

https//www.racom.eu/eng/support/firmware/mr400/help.html

24. Help
Prev		Next

Print version

24. Help

Under this item of menu are offered some possibilities, e.g. how to control a remote CU or how to work with path packets.

From MORSE main menu type ? Enter

Shell commands:
!hXXXX - remote mode, destination XXXX(hex)
!dXXXX - remote mode, destination XXXX(dec)
!l     - local mode
!RSS (or ! itself) - Received Signal Strength service
!p - path
!pN - path C92
!pXXXXX - change last 1..4 bytes in current path to XXXXX
!pNXX   - dtto for path C92
>>

`!hXXXX`	— the control is switched over to the remote CU with hexadecimal address `XXXX` (it is sufficient to type the right-most digits which differ from the previous address)
`!dXXXX`	— the control is switched over to the remote CU with decimal address `XXXX`
`!l`	— reverts the control back to the local CU
`!RSS or !`	— after putting in the `!hXXXX` command you can by this command obtain the route listing with Received Signal Strength printout
`!p`	— activates the path defined in `(p)ath` menu, it is possible to examine this path by `!` command
`!pN`	— activates the path in C92 mode
`!pXXXXX`	— changes last bytes in the last address in the current path (it is only used for the path, which has the table part at the end)
`!pNXX`	— changes last bytes similar in the C92 mode
`!mfile`	— starts macro `file.mac` in the running Setr

Prev		Next
23. Path editor	Contents	25. CNI-channel to node interface